next tool that's going there is an inm so notice how it's kind of doing that pocketing routine it's kind of Machining from the center out to kind of give us that little pocket see how fast that's going with the chips [Music] fitting taking the Finish pass it's going back up it's going to Tool change now next tool is what we call the engraving tool so or is that a chering tool what so they're chering with that so they're putting a champer on the edge is that chering tool going to do the engraving to or no this is another tool so and another tool four tools total on this one I believe so y four cting tools total that need to be programmed for this to be able for just this particular uh application to be done and what's our RPM you guys can take a look at the controls and see what the RPM and the feed rate of that uh cutting tool is notice how you see the XYZ uh AIS there and the movement so as we get into our controllers you'll kind of be able to see and tell the same thing and know what's going on and how to read those [Music] controls and of course we are uh making this Buck of the best football team in the country like Philadelphia Eagles there's no doubt so I was a little worried when I didn't see any Eagles uh bucks there I think there is one oh yeah it's up there on the protot top [Music]